Connecting an arduino geiger.
Page 1 of 1

Author:  terrybunker [ Mon Sep 08, 2014 12:07 pm ]
Post subject:  Connecting an arduino geiger.

In the software what serial data is coming across the USB from the Geiger? I don't see where to define the register or data point to be monitored by the software. I'm just counting pulses, not converting to uSv...
Not sure what is happening in the software.
I see that is sees my port, but I see no count ever in the software.
It is also resetting my arduino about once a minute..
Any suggestions?

Author:  terrybunker [ Tue Sep 09, 2014 1:55 pm ]
Post subject:  Re: Connecting an arduino geiger.

Can anyone tell me what data I am supposed to send to the wapp4netc and in what interval?
I can connect, but nothing records. I am currently sending CPM once a minute...
Any help would be appreciated.

Author:  Lee971 [ Tue Sep 09, 2014 8:51 pm ]
Post subject:  Re: Connecting an arduino geiger.

Hello Terrybunker, welcome to NETC. This sounds pretty technical. Email they should be able to answer your question.

Author:  hey [ Tue Sep 09, 2014 9:49 pm ]
Post subject:  Re: Connecting an arduino geiger. does not support arduino geiger. We are working on MRU ( Mobile Radiation Unit ) using the Ham radio 2-meter band and do not have the time to work on another project. Sorry.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group